How to install hollow carved aluminum panels?

How should the hollow carved aluminum plate factory install it?

1. Fixed hollow carved aluminum plate

Install hollow carved aluminum panels according to the drawings. It should be noted that the aluminum alloy veneer must be firmly installed on the steel frame. The surfaces of two adjacent aluminum alloy plates must be tightly welded, with a gap between 10 and 15mm. The left and right errors should be controlled within 1.5mm, and the upper and lower errors should be controlled within 1.5mm.

2. Seal injection

After the board is cleaned and tidy, immediately place the anti-corrosion and anti-corrosion items at the connection between the adjacent two boards, and then carefully bond them. It should be noted that the adhesive is very particular and must be sealed with sealant. Be careful not to create gaps or bubbles during the injection process.

3. This process is closed

The tools can be reused here, with metal plates covering the ends of the wall panels and keel sections.

4. Processing deformation joints

When other irregular shapes are needed, deformation joints can be used.

5. Cleaning

All dirt, adhesive marks, tape, and other debris on the surface of the hollowed out carved aluminum panel make the panel surface clean and bright.